SpeedSpy Extension Cable extends SpeedSpy upto 2 feet from the Data Link Connector.
This SpeedSpy product is ideal for customers seeking a cost effective easy to use "Plug and Drive" solution for Setting, Monitoring and
Enforcing the maximum allowed speeds for motor vehicles. It
can be used in ALL light vehicles (cars, small
trucks, SUV's and vans) manufactured since
1996.
It is simply plugged into the vehicle Data Link
Connector (DLC)
located inside the cabin under
the dashboard.
The SpeedSpy is fully self contained and does not require batteries a
computer or special download process and software. Set-up is accomplished
by
use of 2 tactile switches and a pair of seven-segment displays. Over
Speed violations and Tampering are stored in memory and directly displayed. Access to
the
set-up process and violations data requires entry
of the user defined 4
digit PassCode.
When the vehicle is in motion, the EXACT same speed as the vehicle
speedometer will be displayed
on the SpeedSpy. If the maximum allowed
speed is exceeded, a loud and annoying buzz is produced until the speed is
reduced to below the maximum speed allowed. Each time this happens, the
violations count
is incremented and stored.
If there are any speed violations or tampering
incidents, they will be
indicated by the display of OS (Over Speed) and/or td (tampering
detected) and a chirping sound when the vehicle is NOT in motion
or the ignition is switched OFF.
In addition, when there is a violation a simulated
low level "Cricket"
chirping sound is produced to call attention to the violation(s) status. This
continues
even with the ignition turned off. It can only be extinguished
by the product user entering a
PassCode.
A few examples of customers are High School
Drivers Education
programs, concerned parents
of teen drivers and fleet operators enforcing a
fuel efficient (55 Mph) driving speed.
